This error is common to all USB devices, not only the USB flash disk.When the USB device plugged into computer operating system will report:
1. Exposed by the USB connection is not good:
- Can be plugged in when not well exposed or leaked early on to icusb controller (sometimes going through the resistor or capacitor -replace the resistors and capacitors to try this).
2.Two. Pressure drop
on the way:
- Apply 3v3 sources because leaks that have fallen so low over the remaining approximately 2v.
- Most of the damage Zenner, ic filter capacitor voltage or power.
- Apply 3v3 sources because leaks that have fallen so low over the remaining approximately 2v.
- Most of the damage Zenner, ic filter capacitor voltage or power.
3. Quartz Death:
- It so happens, if in doubt rather try a 12MHz quartz to eliminate this ability is finished.
- It so happens, if in doubt rather try a 12MHz quartz to eliminate this ability is finished.
4. Error Control IC:
- If you have checked the steps are OK, but nothing can improve the controller IC has failed. It would not die but was not operating as desired. How to handle the change control IC (true type) or replace in case of death as driver ICs.
This applied to all USB devices, not just USB Flash disk soreness.
- If you have checked the steps are OK, but nothing can improve the controller IC has failed. It would not die but was not operating as desired. How to handle the change control IC (true type) or replace in case of death as driver ICs.
This applied to all USB devices, not just USB Flash disk soreness.
No comments:
Post a Comment